How does the washing machine clean the pump

It is necessary to check whether the drainage pump can work normally. If it is normal, it can be cleaned the filter of the drainage pump, and then open the drainage switch, discharge the water for many times, and discharge the dirt inside.

1. When cleaning the filter of the drum washing machine, pour the special detergent of the washing machine into the water, pour it into the washing machine to the normal water level, wash the machine according to the normal washing mode, stop about 20 minutes later, wait two hours and continue to run the washing machine for 30 minutes, then drain the water and dry the drum with the lid open.

2. When detecting the drainage pump of the ordinary washing machine, open the drainage switch on the control table of the washing machine for washing selection, and then use a multimeter to measure the resistance between the two edges of the plug, so that the resistance value of the whole drainage pump can be measured when working. If the resistance value measured is consistent with the nominal resistance value of the manual, it indicates that the drainage pump is normal; If the resistance value measured is zero or infinite, it indicates that the discharge pump motor coil has short circuit.

3. Check the position of the drainage valve of the drum washing machine, and sometimes forget to check whether there is anything in the clothes when washing clothes, resulting in the high-speed rotation of clothes in the process of recleaning, the things in the pockets fall out, if it is hard things may hang the inner wall of the washing machine, if it is toilet paper and other things may block the drain. After cleaning the drainage outlet, the drainage mode can be opened and the water can be eliminated for many times. At the same time, the water is discharged and the cleaning drainage pump is in the disguised phase.